Subaru Automobile Electronics H7110FS300 User Manual

REMOTE KEYLESS  
ENTRY SYSTEM  
FORESTER  
INSTALLATION  
INSTRUCTIONS  
P/N: H7110FS300  
Kit Contents:  
1
2
1
Keyless Entry Control Module w/Integral Bracket  
Remote Control Transmitters  
Installation Manual  
Tools Required:  
#1 Flat-tip Screwdriver  
#2 Phillips Head Screwdriver (short)  
1/4” Drive Ratchet  
4-inch 1/4” Drive Extension  
1/4” Swivel  
10 mm Socket  
This device complies with FCC rules part 15. Operation is  
subject to the following two conditions: (1) this device may  
not cause harmful interference and (2) this device must  
accept any interference that may cause undesired operation.  
1
99.11  
UT27T-11  
Printed in Japan  
 
3. Remove two M6 nuts, indicated by arrow in Figure 3,  
securing both the door lock timer module. Retain nuts  
for installation of keyless entry module. Disconnect the  
door lock timer harness from the module and discard the  
module. Disconnect 6-pin to 16-pin extension harness  
from the 16-pin (white housing) connector. Discard the  
extension harness.  
Figure 3  
4. Insert the 16-pin (white housing) connector into the key-  
less entry module.  
5. Install the keyless entry module to the location previ-  
ously used by the door lock timer module and secure it  
in place with two M6 nuts removed in Step 3. Refer to  
Figure 4 which shows the installed keyless entry mo-  
dule.  
Figure 4  
NOTE:  
The installed direction of the keyless entry module  
should be as shown in Figure 5.  
Figure 5  
3
 
C. System Test  
1. Reconnect the negative battery terminal.  
2. Close all vehicle doors (with dome light switch set to “Doors”).  
3. Depress the LOCK/ARM button on the remote and the following should be observed:  
3.1 All vehicle doors will lock  
3.2 The vehicle courtesy (dome) light will turn off  
3.3 The horn will chirp once.  
4. Depress the UNLOCK/DISARM button on the remote and the following should be observed:  
4.1 The driver’s door will unlock  
4.2 The vehicle courtesy (dome) light will turn on (for a maximum of 30 seconds unless a door  
is opened and/or the ignition key is turned on)  
4.3 The horn will chirp twice.  
5. Depress the UNLOCK/DISARM button a second time and the remaining doors should unlock.  
6. Depress and hold the LOCK/ARM button (panic mode) for more than 2 seconds and the following  
should be observed:  
6.1 The horn will sound (for a maximum of 30 seconds or until a button on the remote is  
depressed).  
7. Depress any button on the remote and the horn should stop sounding.  
8. Depress the UNLOCK/DISARM button.  
9. Simultaneously depress and hold the LOCK/ARM and UNLOCK/DISARM buttons for more than  
2 seconds and the following should be observed:  
8.1 The horn will chirp 2 times indicating that the audible verification has been turned off.  
10. Depress the LOCK/ARM button on the remote and the following should be observed:  
9.1 All vehicle doors will lock  
9.2 The vehicle courtesy (dome) light will turn off  
9.3 NO HORN SHOULD BE HEARD.  
11. Depress the UNLOCK/DISARM button on the remote and the following should be observed:  
10.1 The driver’s door will unlock  
10.2 The vehicle courtesy (dome) light will turn on (for a maximum of 30 seconds unless a door  
is opened and/or the ignition key is turned on)  
10.3 NO HORN SHOULD BE HEARD.  
12. Simultaneously depress and hold the LOCK/ARM and UNLOCK/DISARM buttons for more than  
2 seconds and the following should be observed:  
11.1 The horn will chirp 1 time indicating that the audible verification has been turned on.  
13. Repeat steps 3 and 4 to ensure that audible mode is once again functioning.  
14. Repeat steps 2 through 7 with the second remote transmitter.  
D. Notes on System Operation  
1. The panic mode will remain active for 30 seconds unless another button on the remote is activated  
to cancel the mode.  
2. If any secured opening (including rear hatch) is open at the time of depressing LOCK/ARM on the  
remote transmitter, the horn will chirp 3 times indicating that all openings have not been properly  
closed. Upon closing, all doors will lock automatically.  
3. Audible “ON” “OFF” can not be toggled unless the driver’s door is unlocked.  
4
 
E. Finish the Installation  
1. Replace the lower dash panel below the steering column previously removed in section B.  
2. Reset presets on radio as noted in step 1. b. in section A. Pre-Installation Notes.  
Installation is now complete.  
5
 

Sharp All in One Printer MX M1100 User Manual
Sharp Calculator EL 520W User Manual
Silva GPS Receiver DGPS 200 User Manual
Snapper Lawn Mower Z6002M User Manual
Snapper Trimmer 214DCST User Manual
Sony Stereo Receiver STR DE725 User Manual
Spin Master Motorized Toy Car Room Raider User Manual
Spin Master Motorized Toy Car Twin Fury User Manual
Sunrise Medical Mobility Aid Trek 4 User Manual
SUPER MICRO Computer Computer Hardware R1K62BP User Manual